TStE275TM steel plate/sheet/ Supply from stock
We can produce TStE275TM steel palte,TStE275TM sheet,TStE275TM coil,TStE275TM Steel Strips,TStE275TM round bar,TStE275TM flat bar.Supply from stock.
TStE275TM steel palte Specifications:50mm-4500mm(width)*0.08mm-1000mm(thickness).
TStE275TM Steel sheet Specifications:50mm-4500mm(width)*0.08mm-1000mm(thickness).
TStE275TM Steel coil Specifications: 50mm-4500mm(width)*0.08mm-1000mm(thickness).
TStE275TM Steel Strips Specifications:50mm-4500mm(width)*0.08mm-1000mm(thickness).
DIN-SEW083 TStE275TM steel plate/sheet for Fine-grain structural steels, thermomechanically rolled steels
DIN-SEW083 TStE275TM steel plate/sheet,DIN-SEW083 TStE275TM steel plate/sheet, under DIN standard, we can regard TStE275TM steel plate/sheet for Fine-grain structural steels, thermomechanically rolled steel.
DIN-SEW083 TStE275TM is a technical delivery conditions for thermomechanical rolled weldable fine grain structural steels.It is according to DIN-SEW083 standard.S means the structural steel, M means the delivery condition.Capital letter L for the quality with specified minimum values of values of impact DINergy at temperature not lower than -50 degree.
| TStE275TM DIN-SEW083 Number:1.8819 | Comparision of steel grades | |
| EN10113-3 | S275ML | |
| UNI 7382 | Fe E 275 KTTM | |
| BS 4360 | - | |
| ASTM | - | |
Chemical Composition of DIN TStE275TM steel,by %
| Grade | C max | Si max | Mn max | P max | S max | N max | AL max | Nb max | V max | Ti max | Cr max | Ni max | Mo max | Cu max | CEV max |
| TStE275TM | 0.13 | 0.50 | 1.5 | 0.025 | 0.02 | 0.015 | 0.02 | 0.05 | 0.08 | 0.05 | 0.30 | 0.3 | 0.10 | 0.55 | 0.38 |
Mechnical Properties of DIN TStE275TM steel
| Temperature | -50 | -40 | -30 | -20 | -10 | 0 | 20 |
| Notch impact test. Min. absorbed DINergy | 27 | 31 | 40 | 47 | 51 | 55 | 63 |
| Nominal thickness(mm) | to 16 | 16-40 | 40-63 | 63-80 | 80-100 | 100-120 |
| ReH-Minimun yield strDINgth(Mpa) | 275 | 265 | 255 | 245 | 245 | 240 |
| Nominal thickness(mm) | to 40 | 40-63 | 63-80 | 80-100 | 100-120 |
| Rm-TDINsile strDINgth(Mpa) | 370-530 | 360-520 | 350-510 | 350-510 | 350-510 |
| Nominal thickness(mm) | - | ||||
| A-Minimum elongation Lo=5,65√So(%) | 24 | ||||
TStE275TM Mechanical properties
TStE275TM Heat treatment
TStE275TM Machining
